Use "resistor" in a sentence
resistor example sentences
resistor
1. connected to 100 Ohm resistor
2. Step4: If you are using a 9volt battery , please use a 100 ohm protective resistor with battery wire, to limit battery voltage to around 6 volt
3. Connect a 22k resistor between A and C and a 100k resistor
4. Connect a 20K resistor between A and C and a 10 k resistor
5. power (p) consumed by the resistor can be expressed in
6. resistor out of the circuit you can measure its resistance
7. The fixed resistor will have one value which will never
8. tapped resistor has several fixed taps and makes more than
9. to tap off any resistance within the range of the resistor
10. This tells how accurate is the resistance any variable resistor can probably be called a rheostat
11. The 5-band resistor
12. true value of the resistor could be 5% more or less
13. The last band on a 6-band resistor is the tem-
14. painted on the resistor, while on some other systems 5
15. resistors, they can also apply to capacitors and other large resistor values, the abbreviations k and M are components
16. On a 4-band resistor, the first two
17. that a resistor can safely dissipate
18. RNW (resistor network): This is one of the more
19. a pCB, when one side of each resistor is to be con-
20. a bridge rectifier converts ground, while the resistor R2 (between adj pin and the aC to pulsating DC with a peak voltage level output pin) is a fixed 220-ohm resistor
21. kilo-ohm resistor R1 limits the current through
22. Discrete resistor (with 1% tolerance) switch-
23. resistor, further clock pulses at the input of N4
24. Resistor R1 is selected so
25. resistor R1, whose other
26. through another current limiting resistor R1 (as by using an insulating adhesive (such as Elfy or Fevi-shown in the figure)
27. This high voltage appears initially across resistor
28. the values of capacitor C1 and/or resistor R2
29. and resistor R3, with its
30. in this process due to the presence of resistor R1 and To slow down the speed of the glowing LEDs, you may capacitor C1 at the input of N2
31. the internal resistor of iC2
32. and resistor R5, and thus
33. farads) The formula may vary for other resistor R1 and capacitor
34. duty cycle is zero; with 25% duty cycle the average effectively provide different timing resistor values dur-value is 1
35. ground via resistor R2 (1-meg-ohm)
36. along with its series biasing resistor R3
37. addition of resistor R5 and
38. connected to the counter/decoder via a resistor, and
39. The resistor across the capacitors provides a ing an insulated ferrite toroidal core are given in discharge path for the capacitors after the battery the schematic
40. refurbished the given drones by putting in the resistor chips next to their power supply
41. But there is no current running through it Maybe there is some kind of resistor preventing it Maybe it’s my thinking brain
42. Maybe it’s wax dripping from the condenser or charcoal built up on a resistor
43. Power source, triode, resistor, coil